Buy Best Real IBM 000-332 Free Dumps Easily

Welcome to download the newest Newcerts 000-332 VCE dumps:

Attention Please: Professional new version IBM 000-332 PDF and VCE dumps can now free download on, all are updated timely by our experts covering all new questions and questions. 100 percent pass your IBM 000-332 exam.

PowerHA automatic error notification for shared data volume groups traps on which specific error?

Correct Answer: D QUESTION 2
Failure to plan for which element will have a negative impact on PowerHA cluster availability, when using virtual I/O resources on the cluster nodes?
A. Planning for NPIV capable SAN switches
B. Planning for Etherchannel capable switches
C. Planning for update of Virtual I/O Servers
D. Planning for at least 2 virtual Ethernet adapters for each cluster network and each node

Correct Answer: C QUESTION 3
What must be verified before configuring GLVM?
A. TCP/IP communication between sites is possible.
B. A replacement IP address is configured for XD_IP network.
C. The PowerHA cluster resource definition is completed on the primary site.
D. Shared volume groups for Geographically Mirrored Volume Groups are configured.

Correct Answer: A QUESTION 4
An administrator finds that a colleague has increased the size of a file system in an Enhanced Concurrent Volume Group using base AIX commands. How can the administrator make the cluster configuration consistent again?
A. Run chfs on the other cluster nodes.
B. Run Extended Verification and Synchronization.
C. Run the synclvodm command on all cluster nodes.
D. Run Synchronize a Shared Volume Group Definition.

Correct Answer: D QUESTION 5
In which configuration would an AIO Cache LV be required?
A. Cross-site LVM
B. Synchronous GLVM
C. Asynchronous GLVM
D. When using mirror pools

Correct Answer: D QUESTION 6
Given the following cluster.mmddyyyy log file output, what has happened?
Mar 29 06:09:22 EVENT START: network_down -1 net_ether_01 Mar 29 06:09:22 EVENT COMPLETED: network_down -1 net_ether_01 0 Mar 29 06:09:29 EVENT START: network_down_complete -1 net_ether_01 Mar 29 06:09:29 EVENT COMPLETED: network_down_complete -1 net_ether_01 0
A. Non-redundant network switch has failed
B. One interface in net_ether_01 has failed
C. The service IP address was moved to another adapter
D. Some heartbeat packets have been lost on one node in a cluster

Correct Answer: A QUESTION 7
After installing PowerHA packages, what is the next step when configuring the cluster?
A. Configure cluster networks.
B. Add repository disk to the cluster.
C. Configure persistent IP addresses on all nodes.
D. Add cluster boot addresses, service addresses and hostnames to /etc/hosts.

Correct Answer: D QUESTION 8
In order to utilize PowerHA 7 SAN based communications in a VIO Server environment, what task must be performed on the AIX client nodes?
A. Add a SANhb network into the cluster topology.
B. Add a virtual Ethernet adapter and specify VLAN 3358.
C. Configure/etc/cluster/ifrestrict to specify which HBAs should be excluded.
D. Add another HBA to each VIOS server and add it as avSCSI adapter for this purpose.

Correct Answer: B QUESTION 9
An administrator is configuring a PowerHA 6 cluster to use disk heartbeat as a non IP network. A shared volume group, dhbvg, has been configured using a single disk, hdisklO, on NodeA and NodeB. The administrator believes that the prerequisites have been met, but would like to test connectivity of the disk heartbeat network before adding the network into the cluster.
How can the connectivity of this disk heartbeat network be tested?
A. On NodeA run the command /usr/bin/readvgda-V dhbvg -F statusOn NodeB run the command /usr/bin/ putvgda-V dhbvg -a status=1
B. On NodeA run the command /usr/sbin/rsct/bin/dhb_transmit hdisk10On NodeB run the command /usr/ sbin/rsct/bin/dhb_receive hdisk10
C. On NodeA run the command/usr/sbin/rsct/bin/dhb_read-p hdisk10-rOn NodeB run the command /usr/ sbin/rsct/bin/dhb_read-p hdisk10-t
D. On NodeA run the command “echo 1 | /usr/bin/dd of=/dev/rhdisk10 bs=4K skip=2 count=1″On NodeB run the command/usr/bin/dd if=/dev/rhdisk10 bs=4K skip=2 count=1”

Correct Answer: C QUESTION 10
There is a two-node cluster with Node1 and Node2. An administrator changes filesystem size on Node1 by
using the chfs command, and moves resource the group to Node2.
The administrator finds the change of filesystem size is recognized on Node2.
Why is the filesystem size change reflected on Node2?

A. The gsclvmd daemon automatically synchronizes filesystem changes.
B. The filesystem size change is recognized when filesystem is mounted on Node2.
C. A pre-event is defined to get_disk_vg_fs event to reflect filesystem size change.
D. The shared volume group is re-imported on Node2 by lazy update when moving the resource group.

Correct Answer: D QUESTION 11
A 2-node cluster has three multi-node disk heartbeat (MNDHB) networks and data volume groups on separate disks. Application resource groups are online on Node1. What happens if Node1 loses access to two of the three MNDHB disks?
A. Node1 halts
B. Application resource groups move to Node2
C. Application resource groups remain on Node1
D. Application resource groups on Node1 go offline

Correct Answer: C QUESTION 12
What is the command used to check the status of all interfaces and hearbeats in a PowerHA 7 cluster?
A. cllsif-p
B. cltopinfo-m
C. Iscluster-i
D. Issrc-Is topsvcs

Correct Answer: C QUESTION 13
An administrator has a 2-node cluster and has chosen the C-SPOC option to bring a resource group offline. The resource group was stable on the primary node prior taking resource offline, however it has gone into an error state. The administrator corrects the error and issues the clruncmd to continue cluster processing.
What will happen to the resource group?
A. The resource group goes offline.
B. The resource group falls over to the remaining active node.
C. The node shuts down and the resource group goes into temporary error state.
D. The resource group remains in error state until services on all cluster nodes are stopped and restarted.

Correct Answer: A QUESTION 14
After upgrading one node of a 2-node cluster to PowerHA 7, an administrator discovered that the wrong disk was chosen for the repository disk. What must be modified on both nodes to correct this error without starting over from the beginning?
A. HACMPsircol
B. HACMPcluster
C. cluster.conf
D. clmigcheck.txt

Correct Answer: D QUESTION 15
When using PowerHA 7, a shared volume group (VG) must be configured as___________.
A. Scalable VG
B. Cluster aware VG
C. Concurrent capable VG
D. Enhanced concurrent VG

Correct Answer: D QUESTION 16
An administrator adds a new network interface to each node in a 2-node PowerHA 7 cluster, and sets the IP addresses. When is the new network interface used for heartbeating?
A. Immediately
B. After refreshing clcomd
C. After the cluster is synchronized
D. When restarting PowerHA on both nodes

Correct Answer: A QUESTION 17
What does the gsclvmd daemon do?
A. Enhanced concurrent mode file system names are kept synchronized across nodes
B. New enhanced concurrent mode volume group definitions are imported to all nodes
C. Enhanced concurrent mode logical volume sizes are kept synchronized across nodes
D. Quorum is maintained across cluster disks for enhanced concurrent mode volume groups

Correct Answer: C QUESTION 18
A PowerHA 6 cluster has missed too many heartbeats during a large disk write operation, and has triggered the deadman switch. Which tunable can help ensure that HA Cluster Manager continues to run?
A. I/O Pacing and syncd frequency
B. I/O Pacing and asynchronous I/O
C. Syncd frequency and asynchronous I/O
D. Asynchronous I/O and disk queue_depth

Correct Answer: A QUESTION 19
A company is determining how they can use DLPAR operations within PowerHAto maximize the usage of their system. Which DLPAR attribute can be controlled through PowerHA?
A. The physical I/O adapters that will need to move to an application server
B. The LPAR CPU Shared Pool weighting required to start an application server
C. The minimum and desired processing units required to start an application server
D. The minimum and maximum virtual processors required to start an application server

Correct Answer: C QUESTION 20
An administrator has configured a 2-node PowerHA 6 cluster, Node1 and Node2, with no non-IP networks.
Sometime after configuring the cluster, the administrator noticed that Node2 appeared to have been shut down. After restarting Node2 the administrator analyzed the cluster log files in an attempt to determine the cause
of the problem.
The clstrmgr.debug log file contained the following information:
Based on the above information, which of the following could explain why Node2 was shut down?
A. The node was halted due to a DMS_TIMEOUT.
B. Node isolation occurred causing a domain merge.
C. Automatic error notification detected a problem and halted the node.
D. The node was unable to fork a new topology services process due to memory limitations.

Correct Answer: B

CCNA IBM 000-332 Exam Certification Guide is part of a recommended study program from IBM 000-332 that includes simulation and hands-on training from authorized IBM 000-332 Learning Partners and self-study products from IBM 000-332.Find out more about instructor-led, e-learning, and hands-on instruction offered by authorized IBM 000-332 Learning Partners worldwide

Newcerts 000-332 dumps with PDF + Premium VCE + VCE Simulator: